Release tool for SPT/JPT contacts
210 589 02 33 00
P54.18-2600-01
A1 Secondary-releasing JPT socket
1 Use a suitable tool to push contact block (1) out of the end detent position in direction of arrow.
P54.18-2502-06
B1 Removing contacts from socket (JPT)
1 Insert release tool from the front through the openings at the contact receptacle of the socket.
The spring plates of the contact socket (1) are pressed together when this is done.
2 Remove the contacts from the socket by pulling slightly on the relevant cable.
Installation
Check that the contact socket is properly locked in place in the housing by pulling slightly on the cable.
Illustration shows MQS, JPT socket
P54.18-2224-01
A2 Secondary-releasing MQS socket
1 Use a suitable tool to raise the locking plates at the cap (2)..
2 Remove socket housing (3) from the cap (2) in direction of arrow.
Illustration shows 14-pin MQS socket with a socket housing and cover (1)
P54.18-2222-06
B2 Removing contacts from socket (MQS)
1 Insert release tool from above through the opening in the exposed socket housing (1) at the spring plate of the contact socket (2).
2 Press down spring plate of the contact socket and push contact (2) out of the receptacle of the socket housing (1). At the same time, assist the unpinning operation by pulling on the relevant cable.
Installation
Check that the contact socket is properly locked in place in the housing by pulling slightly on the cable.
Illustration shows 18-pin MQS socket