Shown on model 212.002 |
1 | Heat shield |
1s | Screw/bolt |
2s | Screw/bolt |
B70 | Crankshaft Hall sensor |
P15.12-2159-06
| Remove/install | ||
1 | Remove lower engine compartment paneling | ||
2 | Remove screw/bolt (1s) and heat shield (1) | ||
3 | Detach heat grommets from crankshaft Hall sensor (B70) and push to the side at electrical line | ||
4 | Disconnect electrical connection on crankshaft Hall sensor (B70) | ||
5 | Remove screw/bolt (2) and take out crankshaft Hall sensor (B70) | Bolt, position sensor for crankshaft to crankcase/oil pan | |
6 | Install in the reverse order | ||
7 | Carry out default initialization and then sensor rotor adaptation using STAR DIAGNOSIS | Only when replacing the Hall sensor (B70) | |
| |||
8 | Read out fault memory using the diagnostic system and clear if necessary | ||
| Check | ||
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
9 | Perform an engine test run and check engine for leaks |