1 | Nut |
2 | Heat shield |
3 | Electrical connector |
4 | Screw |
B70 | Crankshaft Hall sensor |
P15.12-2232-05
Caution | Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. | |
Warning | Risk of injury. Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | |
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
| Remove/install | ||
1 | Remove center and rear sections of lower engine compartment lining. |
| |
Engine 264 in model 257 | |||
2 | Unscrew nut (1) and remove heat shield (2). | M81.25 | |
3 | Release and disconnect electrical connection (3). | ||
4 | Remove screw (4) and pull out crankshaft Hall sensor (B70). | Screw/bolt, crankshaft position sensor to crankcase | |
5 | Install in the reverse order. | ||
6 | Read out and delete fault memory. | ||
| Engine 264 in model 238 | ||
| Engine 264 in model 213 | ||
| Engine 264 in model 257 | ||
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
7 | Perform an engine test run and check the engine for proper function. |