W14.40-1617-09
1 | Pump module | 5 | Filter element | 9 | Sealing bead (on frost protection membrane (6)) | ||
2 | Connecting body | 6 | Frost protection diaphragm | 10 | Thread | ||
3 | Pin | 7 | O-ring | 11 | Ventilation | ||
4 | O-ring | 8 | Filter housing |
Danger ! | Risk of burn injuries and scalding when working at AdBlue lines and the components attached to them. Risk of injury to skin and eyes when handling AdBlue. Risk of poisoning caused by swallowing AdBlue | Pour AdBlue into suitable containers only. Wait until the pressure is released before starting any work on the exhaust aftertreatment system. | |
| Notes on avoiding damage through contamination and foreign objects | ||
| Notes on use, material properties and handling of AdBlue® | ||
| Remove | ||
1 | Remove filter housing (8) | ||
2 | Remove O-ring (7) | ||
3 | Remove frost protection membrane (6) | Catch escaping AdBlue® with a dry clean cloth. | |
4 | Remove filter element (5) | Remove filter element (5) through light turning and pulling. | |
| Install | ||
5 | Push vent (11) into hole provided in filter housing (8) until it engages with audible click | Only if the vent (11) has not already been installed in the filter housing (8) and instead is provided separately. | |
6 | Install air filter element (5) | To do this place filter insert (5) over the pin (3) and press in all of the way. | |
7 | Place frost protection membrane (6) over the filter element (5) on the connecting body (2) | The groove on the connecting body (2) must be free of dirt and foreign objects. | |
8 | Spray sealing bead (9) of the frost protection membrane (6) circumferentially with lubricant | | |
Biolube L spray | |||
9 | Spray thread (10) on connecting body (2) with lubricant | | |
Biolube L spray | |||
10 | Insert O-ring (7) into the intended groove in the filter housing (8) | The groove must be free of dirt and foreign objects. | |
11 | Install filter housing (8) | Filter housing to pump module |