W14.15-1014-06
1 Exhaust pipe
2 Clip
3 Engine brake cylinder
4 Turbocharger
5 Compressed-air line
6 Heat shield
7 Engine brake flap connection
| Remove/install | ||
1 | Switch off ignition | ||
Danger! | Risk of explosion caused by escaping oxyhydrogen gas. Risk of injury caused by caustic burns to eyes, skin and mucous membranes from battery electrolyte (contains diluted sulfuric acid) or metal spatter due to short circuit. Risk of burn injuries caused by short circuit. Risk of poisoning caused by swallowing battery electrolyte (contains diluted sulfuric acid) or absorption of lead over the skin or orifices | No fire, sparks, open flames or smoking. Wear acid-resistant gloves and clothing and safety glasses with side guards. Do not place any conductive objects on the battery and avoid any short circuit from battery positive to ground. Only fill liquid battery electrolyte (diluted sulfuric acid) into suitable and appropriately marked containers. | |
2 | Disconnecting the battery | See information from vehicle manufacturer. | |
| Notes on battery | ||
3 | Open engine hood | See information from vehicle manufacturer. | |
4 | Remove clamp (2) on exhaust pipe (1) | Installation: Clean sealing surfaces and check clamp (2) for wear, replace clamp (2) if necessary. | |
5 | Loosen all clamps on exhaust pipe (1) up to the rear muffler | ||
6 | Remove heat shield (6) | ||
7 | Detach compressed air line (5) at engine brake cylinder (3) | ||
8 | Remove engine brake flap fitting (7) | Installation: Clean sealing surfaces. | |
| |||
| Notes on self-locking nuts and bolts | ||
9 | Inspect engine brake flap fitting (7) for wear | If worn: | |
Repair engine brake flap fitting (7). | |||
10 | Install in the reverse order |
Exhaust manifold