P13.22-2113-11
1 Poly-V-belt
2 Tensioning device
| Remove | ||
1 | Open engine hood and raise to vertical position | ||
2 | Remove engine cover | ||
3 | Remove engine charge air channel upstream of charge air cooler | ||
4 | Loosen poly-V-belt (1) | To relieve the tension at the poly-V-belt (1), turn the tensioning device (2) in the direction of the arrow. | |
| Pin for locking poly V-belt tensioning device | ||
5 | Remove poly-V-belt (1) | ||
| Check | ||
6 | Inspect belt pulley sections and tensioning device (2) for damage and dirt | Installation: In the event of damage to the belt pulley or the tensioning device (2), these must be replaced. | |
7 | Check poly-V-belt (1) | Installation: In the event of wear and tear or damage, the poly-V-belt (1) must be replaced. | |
| Check poly-V-belt in visible area for wear | ||
| Install | ||
8 | Fit on poly V-belt (1) | Do not use belt wax or any similar products. | |
When fitting the poly-V-belt (1), the routing diagram must be observed, see: | |||
Routing diagram of poly V-belt | |||
9 | Install engine charge air channel upstream of charge air cooler | ||
Danger! | Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the running engine | Secure vehicle to prevent it from moving by itself. | |
10 | Carry out engine test run | ||
11 | Reinstall engine cover | ||
12 | Close engine hood |