1 | Engine cover |
2a | Engine cover |
2b | Engine cover |
3a | Engine air intake duct |
3b | Engine air intake duct |
4a | Engine compartment cover |
4b | Engine compartment cover |
4c | Engine compartment cover |
4d | Engine compartment cover |
P01.00-3421-06
5 | Tensioning device |
6 | Hexagon |
7 | Guide pulley |
8 | Upper guide pulley |
9 | Drift |
P13.20-2105-06
Danger ! | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
| Remove/install | ||
1 | Remove engine covers (1, 2a, 2b) | ||
2 | Remove engine air intake ducts (3a, 3b) | ||
3 | Slacken poly-V belt and remove | Routing diagram for poly-V belt | |
Installation: | |||
To do so, swivel clamping device (5) at hexagon (6) counterclockwise, remove poly-V belt and detension clamping device (5). | |||
Installation: Observe poly-V belt routing diagram. | |||
4 | Check belt pulley profile, tensioning device (5) and guide pulleys (7, 8) | Check for damage, wear and soiling. | |
5 | Remove lower engine compartment paneling | ||
6 | Lock tensioning device (5) | Installation: After laying on the poly-V belt, swivel tensioning device (5) at hexagon (6) clockwise, pull out drift (9) and detension tensioning device (5). | |
Swivel tensioning device (5) at hexagon (6) counterclockwise and lock in place using drift (9). | |||
7 | Remove screw/bolts on tensioning device (5) | Bolt, poly-V belt tensioning device to timing case cover | |
8 | Remove tensioning device (5) downwards | ||
9 | Remove left charge air line | ||
10 | Remove screw/bolts for guide pulleys (7) | Bolt, guide pulley to coolant pump/oil filter/timing case cover | |
Bolt, guide pulley to carrier | |||
11 | Remove guide pulleys (7) | ||
12 | Detach upper guide pulley (8) and carrier from timing case cover | Bolt, guide pulley to coolant pump/oil filter/timing case cover | |
13 | Remove screw/bolts for upper guide pulley carrier (8) | Bolt, guide pulley carrier/ABC pump to timing case cover/coolant pump | |
14 | Install in the reverse order |