S09.41-4646-78
1 | Boost pressure sensor | 3 | Electrical connector | |
2 | Bolts |
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
Topical note | Notes on avoiding damage through contamination and foreign objects | ||
| Remove/install | ||
1 | Switch off ignition and store transmitter key outside of transmission range (min. 2 m). | ||
2 | Remove air duct segment together with air ducts. | WIS Service Media | |
3 | Remove upper engine cover. | Installation: Only install upper engine cover after the leak test. | |
4 | Disconnect electrical connector (3). | ||
5 | Unscrew bolts (2). | M5 | |
6 | Remove boost pressure sensor (1) and seal openings with suitable stop plugs. | Record plug | |
7 | Replace sealing ring of boost pressure sensor (1). | If boost pressure sensor (1) is reused. | |
Assembly tool | |||
8 | Install in the reverse order. | ||
9 | Read out and delete fault memory. | If boost pressure sensor (1) is replaced. | |
| |||
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
10 | Perform engine test run and check boost pressure sensor (1) for leaks. |
000 589 93 63 00
Assembly tool
129 589 00 91 00
Record plug