S09.40-4507-08
1 Engine charge air duct
2 Bolt
5 Bracket
6 Bolt
3 Noise insulation
4 Bolts
| Remove/install | ||
1 | Remove engine trim panel | Installation: Only install engine cover only after checking for leaks. | |
2 | Remove bolt (2) on engine charge air duct (1) | | |
3 | Remove bolts (4, 6) on noise damper (3) | | |
4 | Remove bracket (5) | ||
5 | Remove noise damper (3) with engine charge air duct (1) | Clean and close off open connectors for charge air system to avoid damaging engine through sucked in dirt particles. | |
Installation: Install new sealing rings and using liquid lubricant. | |||
| |||
Lubricant | |||
6 | Remove noise damper (3) from engine charge air duct (1) | Installation: Install new sealing ring and using liquid lubricant. | |
Lubricant | |||
7 | Install in the reverse order | ||
| Checking | ||
Danger! | Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running | Secure vehicle to prevent it from moving by itself. | |
8 | Perform engine test run and check connecting point in area of engine charge air duct (1) for leaks |
Charge air pipe/charge air cooling
Number | Designation | Engine | ||
BA09.41-N-1001-01O | Bolt, engine charge air duct on turbocharger to holder | Nm | 9 | |
BA09.41-N-1003-01O | Bolt, turbocharger noise damper to holder | Nm | 9 | |
Set of protective covers
001 589 01 91 00
Repair materials
Number | Designation | Order number |
BR00.45-Z-1002-06A | Lubricating paste, rubber parts 2.5 kg, DB supply specification 6867.00 | A 000 989 01 60 |