1 | Electrical connector |
2 | Engine air intake duct |
3 | Clip |
4 | Air cleaner housing |
P09.10-A033-05
Caution | Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. | |
Topical note | Notes on avoiding damage through contamination and foreign objects | ||
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
| Remove/install | ||
1 | Remove upper engine cover. | ||
| |||
2 | Release and disconnect electrical connector (1) of the pressure sensor downstream of the air filter. | ||
3 | Remove engine air intake duct (2). | ||
4 | Release clamp (3). | ||
5 | Remove cap of the air filter housing (4). | ||
6 | Remove lower part of the air filter housing (4). | Installation: Wet elastomer bearings with lubricant and press lower part of the air filter housing (4) evenly into the elastomer bearings. | |
Lubricant | |||
| Check | ||
7 | Check elastomer bearings for wear and damage. | If there is a problem, | |
| |||
replace elastomer bearing. | |||
8 | Install in the reverse order. |