Shown on engine 274.9 in model 213.042 |
1 | Air cleaner housing |
2 | Air intake line |
3 | Clip |
4 | Air intake pipe |
P09.10-2311-06
Caution | Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. | |
Topical note | Notes on avoiding damage through contamination and foreign objects | ||
| Remove/install | ||
1 | Remove upper engine cover. | ||
2 | Release and disconnect electrical connector of the pressure sensor downstream of the air filter. | ||
3 | Remove the air intake line (2). | ||
4 | Release clamp (3). | ||
5 | Remove cap of the air filter housing (1). | ||
6 | Remove lower part of the air filter housing (1). | Installation: Wet rubber guides with lubricant and press lower part of the air filter housing (1) evenly in the rubber guides. | |
Lubricant | |||
| Check | ||
7 | Check rubber guides for wear and damage. | If there is a problem, | |
| |||
Replace rubber guides. | |||
8 | Install in the reverse order. |