1 | Catalytic converter |
2 | Electrical connections |
3 | Bracket |
G3/4 | Right oxygen sensor upstream of catalytic converter |
G3/6 | Right oxygen sensor downstream of catalytic converter |
P07.52-2058-06
1 | Catalytic converter |
2 | Electrical connections |
3 | Bracket |
G3/3 | Left oxygen sensor upstream of catalytic converter |
G3/5 | Left oxygen sensor downstream of catalytic converter |
P07.52-2059-06
| Remove/install | ||
Danger ! | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
Danger ! | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
1 | Switch off ignition | ||
2 | Remove engine compartment paneling | ||
3 | Unclip electrical feed line from the heat shield and bracket (3) | ||
4 | Unclip electrical connections (2) at bracket and separate | ||
5 | Remove oxygen sensors (G3/3, G3/4, G3/5, G3/6) | Installation: Coat thread with heat-resistant lubricant. Ensure correct routing of oxygen sensor lines. | |
Oxygen sensor at catalytic converter | |||
Paste, hot lubrication 1 kg, DB supply specification 6879.20 | |||
Box wrench bit | |||
6 | Install in the reverse order | ||
7 | Read out fault memory with STAR DIAGNOSIS and clear if necessary | ||
| |||
Danger ! | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
8 | Perform an engine test run and check exhaust system for leaktightness |
000 589 71 03 00
Box wrench bit