AR07.15-W-9235J | Remove/install MR/PLD injection lines | 23.11.10 |
ENGINES 900.9 in MODELS 375.1, 970, 972, 975, 976
ENGINES 902.9 in MODEL 375.3, 950.5 /6, 952.5 /6, 953.6, 954.5
ENGINES 902.9 in MODEL 957 except CODE (MS8) Natural gas engine
ENGINES 902.9 in MODELS 375.1, 970, 972, 974, 975, 976
ENGINES 924.9 in MODELS 958.0, 970, 972, 974, 975, 976
ENGINES 925.9 in MODELS 970, 972, 974
ENGINES 926.9 in MODEL 958.0
ENGINES 926.9 in MODEL 950.5 /6, 952.5 /6, 953.6, 954.5, 957, 958.2
W07.15-1209-08
Shown on engine 926.9
1 Engine trim panel
3 Pressure screws
2 Injection lines
| Removing | ||
Danger! | Risk of injury caused by body parts being pinched or crushed as cab is tilted | Ensure that no one is within tilting range of cab as it is being tilted. Always tilt cab all the way to end position and secure with safety strut. | |
1 | Tilt cab | ||
| Notes on tilting the cab | ||
2 | Remove soundproofing on frame at upper left | ||
3 | Remove engine panel (1) | ||
Danger! | Risk of explosion caused by fuel igniting, risk of poisoning caused by inhaling and swallowing fuel and risk of injury to eyes and skin caused by contact with fuel | No fire, sparks, open flames or smoking. Wear protective clothing when handling fuel. | |
4 | Remove injection line (2) | | |
| |||
| Install | ||
5 | Check pressure screws (3) of pressure pipe connections for correct position | | |
6 | Install injection lines (2) | | |
Danger! | Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running | Secure vehicle to prevent it from moving by itself. | |
7 | Conduct engine test run and check injection lines (2) for leaks | Also replace corresponding injection line (2) if necessary. | |
8 | Install engine panel (1) | ||
9 | Install soundproofing on frame above on the left | ||
Danger! | Risk of injury caused by body parts being pinched or crushed as cab is tilted | Ensure that no one is within tilting range of cab as it is being tilted. Always tilt cab all the way to end position and secure with safety strut. | |
10 | Lower cab | ||
| Notes on tilting the cab |
Diesel injection system with unit pumps (MR/PLD)
Number | Designation | Engine Engine | Engine | ||
BA07.15-N-1004-01A | Injection line to pressure pipe connection and unit pump | Nm | 35 | 35 | |
BA07.15-N-1005-01A | Thrust bolt, pressure pipe connection to cylinder head | Nm | 45 | 45 | |
000 589 68 03 00
Box wrench bit
Ring wrench
000 589 07 03 00