2 | Cover |
3 | Electrical connections |
4 | Electrical line |
5 | Air filter housing |
6 | Screw/bolts |
N3/9 | CDI control unit |
P07.08-2212-06
| Information on preventing damage to electronic components due to electrostatic discharge | ||
| Remove/install | ||
1 | Connect diagnostic system and perform commissioning of the CDI control unit (N3/9) | When replacing the CDI control unit (N3/9) | |
| |||
2 | Detach ground line from battery | ||
3 | Remove upper engine cover | ||
4 | Remove screw/bolts (6) and unclip electrical line from boost pressure control pressure transducer on cover (2) and place to one side | ||
5 | Remove cover (2) | ||
6 | Disconnect electrical connections (3) on CDI control unit (N3/9) and place electrical line (4) to one side | ||
7 | Detach CDI control unit (N3/9) from the mount on the air filter housing (5) upwards and remove | ||
8 | Install in the reverse order | ||
| Check | ||
Danger ! | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
9 | Perform an engine test run and check for correct engine running |