1 | Front engine cover |
3 | Bracket |
4 | Electrical connector |
5 | Electrical connector |
8 | Engine wiring harness |
9 | Electrical line |
N3/10 | ME-SFI [ME] control unit |
P07.08-2188-05
2 | Support |
3 | Bracket |
6 | Vacuum reservoir |
7 | Bolts |
8 | Engine wiring harness |
N3/10 | ME-SFI [ME] control unit |
P07.08-2187-06
| Remove/install | ||
Danger ! | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
| Information on preventing damage to electronic components due to electrostatic discharge | ||
1 | Read out transfer variant coding of ME-SFI [ME] control unit (N3/10) using Star Diagnosis | When replacing ME-SFI [ME] control unit (N3/10) | |
| |||
Connect up Star Diagnosis and read data from ME-SFI [ME] control unit (N3/10) into Star Diagnosis. | |||
Installation: Transfer stored data to new ME-SFI [ME] control unit (N3/10). | |||
2 | Switch off ignition | ||
3 | Remove front engine cover (1) | ||
4 | Disconnect Electrical connections (4, 5) on ME-SFI control unit (N3/10) | ||
5 | Pull out ME-SFI [ME] control unit (N3/10) and mount (2) from bracket (3) | ||
6 | Remove screw/bolts (7) and detach ME-SFI [ME] control unit (N3/10) from the mount (2) | When replacing ME-SFI [ME] control unit (N3/10) | |
Bolt, control unit to retaining plate | |||
Only perform operation steps 7 to 12 for removal of the ME-SFI [ME] control unit (N3/10) bracket (3) | |||
7 | Detach engine wiring harness (8) on bracket (3) | ||
8 | Unclip retaining clip for electrical line (9) on bracket (3) | ||
9 | Detach connector housing bracket on bracket (3) | Bolt, connector housing holder to control unit holder | |
10 | Detach vacuum reservoir (6) from bracket (3) | Screw/bolt, vacuum reservoir to bracket | |
11 | Remove screw/bolts for bracket (3) | Bolt, control unit holder to cylinder head/cylinder head cover | |
Bolt, shield over left exhaust manifold to control unit holder | |||
12 | Remove bracket (3) upwards | ||
13 | Install in the reverse order | ||
14 | Carry out sensor adaptation with STAR DIAGNOSIS | When replacing ME-SFI [ME] control unit (N3/10) | |
| |||
Menu guidance: | |||
15 | Release transport protection on ME-SFI [ME] control unit (N3/10) | When replacing ME-SFI [ME] control unit (N3/10) | |
16 | Personalize and activate ME-SFI [ME] control unit (N3/10) | When replacing ME-SFI [ME] control unit (N3/10) | |
Danger ! | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
17 | Carry out an engine test run |