1 | Engine cover |
2 | Bolts |
3 | Electrical connectors |
4 | Electrical connector |
N3/10 | ME-SFI [ME] control unit |
P07.08-2352-06
Caution | Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. | |
Topical note | Notes on avoiding damage to ignition system | ||
Topical note | Notes on avoiding damage through contamination and foreign objects | ||
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
Notes on safety-relevant components | |||
| Remove/install | ||
1 | Start control unit replacement with diagnostic system | When replacing the ME-SFI [ME] control unit (N3/10). | |
| |||
2 | Switch off the ignition and keep the transmitter key outside the transmitter range (at minimum 2 m) | ||
3 | Disconnect battery ground line | ||
4 | Remove engine cover (1) | ||
5 | Remove screw/bolts (2) | Bolt, ME-SFI control unit to air filter housing | |
6 | Release and disconnect electrical connections (3, 4) | ||
7 | Remove control unit ME (N3/10) | Installation: Check the condition and correct seating of the seal in air filter housing. | |
8 | Install in the reverse order | ||
| Check | ||
9 | Read out and erase fault memory | ||
| |||
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
10 | Perform an engine test run and check engine for proper function |