1 | Crankshaft position sensor |
2 | Electrical connector |
3 | Screw |
S07.04-A015-76
Topical note | Notes on avoiding damage through contamination and foreign objects | ||
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
| Remove/install | ||
1 | Remove lower engine compartment lining | ||
2 | Thoroughly clean area around crankshaft position sensor (1). | Assembly cleaner | |
3 | Disconnect electrical connection (2). | ||
4 | Remove screw (3). | Screw, position sensor of crankshaft to timing case | |
5 | Remove crankshaft position sensor (1). | ||
6 | Install in the reverse order | ||
| Check | ||
7 | Read out and delete fault memory. | ||
| |||
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
8 | Perform engine test run. |