Removal and insertion device
403 589 02 33 00
T05.20-0021-01
Removing
1 Insert centering tube (7) into the bearing bore and bolt bearing flange (5) onto crankcase with two bolts M10x25.
T05.20-0022-01
2 Insert spindle tube (8) into the bearing flange (5).
3 Turn spindle tube (8) until the locking pin (10) locks in the slot (arrow) of the spindle tube (8).
T05.20-0023-01
4 Push spindle tube (8) into crankcase and feed the bearing mounting (9) in behind the respective bearing point so that the mount for the bearing (arrow) is pointing in the direction of the star handle.
Remove not more than two camshaft bearings during each operation.
T05.20-0024-01
5 Insert bearing mounting (9) into the camshaft bearing and insert locking piece (10) into the groove behind the bearing mounting (9).
6 Turn star handle in clockwise direction and pull out camshaft bearing.
T05.20-0025-01
7 The collar bearing (21) is pushed out to the rear. For this step, connect the star handle to the bearing flange with the half-shell.
8 Remove extraction tool and take the loose camshaft bearings out of crankcase.
9 Clean bearing points in crankcase.