AR03.30-T-8401B | Remove/install guide bearing in flywheel | 20.6.06 |
ENGINE 441.980 in MODEL 613.355 /364 /365
ENGINE 402.970, 446.938 in MODEL 613.455 /485
T03.30-0007-06
1 Bolt securing flywheel
2 Guide bearing
3 Flywheel
4 Guide drift
5 Internal extractor
6 Countersupport
7 Drift
| Remove/install | ||
1 | Remove transmission | ||
if code B10 fitted | |||
2 | Remove clutch | ||
3 | Fit on engine cranking device (2) | To counterhold flywheel when pulling off guide bearing. | |
| |||
4 | Unscrew two opposite bolts (1) attaching the flywheel and replace each with a guide drift (4) | Installation: - Lightly oil thread and contact surfaces of bolts before installing. - First tighten to specified tightening torque and then to specified tightening angle! | |
| |||
| |||
| |||
5 | Fit on internal extractor (5) and countersupport (6) | | |
| |||
6 | Pull out guide bearing | Installation: Drive in guide bearing using a drift. | |
| |||
The guide bearing can also be knocked out using the drift when flywheel is removed. | |||
7 | Install in the reverse order |
Test and adjustment values for flywheel
Number | Designation | Engine 402.970, | |||
BE03.30-N-1004-03E | Flywheel bolt | M161.5 | Shank length | mm | 75 0 |
Flywheel, driven plate, vibration damper, starter ring gear
Number | Designation | Engine 402.970 | Engine 441.980 | Engine 446.938 | ||
BA03.30-N-1002-01L | Bolt, flywheel to crankshaft | Stage 1 | Nm | 210 | 210 | 210 |
Stage 2 | ° | 95 | 95 | 95 | ||
000 589 33 33 00
Internal puller
Counter stay
Drift
Torque wrench
403 589 05 15 00
000 589 27 33 00
000 589 62 09 01
403 589 02 63 00
Drift
Cranking device
407 589 00 63 00