1 | Drive plate |
1a | Bolts |
2 | Cylinder pin |
3 | Threaded unions |
P03.30-2112-12
| Remove/install | ||
1 | Remove transmission |
| |
MODEL 204 with TRANSMISSION 716.6 | |||
Model 204 with engine 272 with transmission 722.9 (except 722.96) | |||
Model 204.0/9 with engine 272 with transmission 722.96 | |||
2 | Remove clutch | TRANSMISSION 711.6, 716.6 | |
3 | Install retaining lock for crankshaft/starter ring gear |
| |
MODEL 204.08/98 with CODE M005 (4MATIC) | |||
4.1 | Remove screw/bolts (1a) from drive plate (1) | Model 204 with engine 272 with transmission 722 | |
Installation: If no angle tightener is available, it is possible to tighten screw/bolts (1a) further by the specified angle in a single operation using a socket wrench and breaker bar. | |||
Bolt, flywheel or two-mass flywheel / drive plate to crankshaft | |||
4.2 | Remove screw/bolts (1a) from two-mass flywheel (1) | Model 204 with engine 272 with transmission 711 | |
Installation: If no angle tightener is available, it is possible to tighten screw/bolts (1a) further by the specified angle in a single operation using a socket wrench and breaker bar. | |||
5.1 | Remove drive plate (1) from crankshaft flange | Model 204 with engine 272 with transmission 722 | |
Installation: The straight pin (2) determines the installation position of the drive plate (1) or of the two-mass flywheel. | |||
5.2 | Remove two-mass flywheel (1) from crankshaft flange | Model 204 with engine 272 with transmission 711 | |
Installation: The straight pin (2) determines the installation position of the drive plate (1) or of the two-mass flywheel. | |||
| Check | ||
6 | Check threaded union (3) in drive plate (1) | Model 204 with engine 272 with transmission 722 | |
Check for damage and tight seating, if necessary: | |||
| |||
Install new drive plate (1). | |||
7 | Install in the reverse order | ||
8 | Carry out default initialization and then sensor rotor adaptation using STAR DIAGNOSIS | Only when replacing. | |
| |||
Menu guidance: |