Installing rear crankshaft radial sealing ring

AR03.20-G-3063-01CHA

Installing rear crankshaft radial sealing ring

 Caution

Risk of injury to skin and eyes due to handling of engine oil. Risk of poisoning caused by swallowing engine oil

Wear protective gloves, protective clothing and safety glasses.
Do not fill engine oil into beverage containers.

AS18.00-Z-0001-01A

Engine

457.9, 458.9, 541.9, 542.9, 941.9, 942.9 in model 000.001

For a flywheel without race

1

Wet radial shaft sealing ring (1) on the inner sealing lip with engine oil.

 Install radial shaft sealing ring (1) dry on the outer surface.

2

Push radial shaft sealing ring (1) over the flange (2) for the  insertion device.

3

Position flange (2) with the radial shaft sealing ring (1) on the crankshaft flange (3) and screw in available screws (5) of the flywheel.

 The bore (A) in the flange (2) must be positioned over the dowel pin (6) on the crankshaft flange (3).

4.1

For engine 457.9, 458.9
Push washer (7) with the marking "457" over the flange (2).

4.2

For engine 541.9, 542.9, 941.9, 942.9
Push washer (7) with the marking "500" over the flange (2).

5

Push pulling-in sleeve (8) over the flange (2) and screw on nut (9).

6

Press in radial shaft sealing ring (1) with the pulling-in sleeve (8) by screwing on the nut (9) up to a noticeable end stop into the timing case (4).

 The installation depth of the radial shaft sealing ring (1) is prescribed by the  insertion device.

7

 insertion device.