Removing and installing grooved ball bearing of crankshaft

AR03.20-D-8400C

14.2.96

ENGINE 111.979 in MODEL 901, 902, 903, 904

D03.20-1005-11

1 Spacer ring

2 Grooved ball bearing

3 End cover

4  Countersupport

5  Internal extractor

 	Removing, installing
1.1	Remove manual transmission		AR26.10-D-0020B
1.2	Remove automatic transmission	 On models with automatic transmission	AR27.10-D-0500C
2	Remove clutch		AR25.10-D-0050A
3	Assemble internal extractor (5) and countersupport (4)		*000589253300
			*000589333300
4	Pull out grooved ball bearing (2) together with end ring (3)	 Installing: use a suitable drift to insert new grooved ball bearing (2) until it makes contact with the spacer ring. In many cases it is possible to grooved ball bearing by hand. After this, use a suitable drift to knock in new end ring (3) as far as a stop.
5	Take out spacer ring (1); inspect condition and replace if necessary
6	Install in the reverse order

000 589 25 33 00

000 589 33 33 00

Countersupport

Internal extractor