1 | Oil pan bottom section |
2 | Screw |
3 | Electrical connector |
B40 | Engine oil sensor (engine 642.992/993) |
B40/8 | Engine oil sensor (engine 642.896/898.) |
D01.45-1108-06
1 | Oil pan bottom section |
D01.45-1109-06
Danger | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
| Remove/install | ||
1 | Lift/jack up vehicle | ||
2 | Drain engine oil, catch if necessary | ||
| |||
3 | Remove carrier for 2nd A/C compressor |
| |
4 | Disconnect electrical connection (3) from engine oil sensor (B40 or B40/8) | ||
5 | Remove screws (2) | Oil pan bottom section to oil pan top section | |
6 | Pry off oil pan bottom section (1) in the area of the cutouts (arrow) | ||
Notes on sealant path for oil pan | |||
Installation: Clean sealing surfaces of oil pan and oil pan bottom section (1) and apply sealant. | |||
Loctite 7200 | |||
Loctite 7063 (400 ml) cleaning spray | |||
Sealant, Loctite 5970, 50 ml | |||
7 | Install in the reverse order | ||
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
8 | Conduct engine test run and check engine for leaktightness in the area of the oil pan bottom section (1) |