Modification notes
1.10.07 | Use a commercially available open end wrench, size 24 mm, without an extension - added. | Step 4 | |
Special tool torque wrench handle altered. |
Crankcase, timing case cover, end cover
Number | Designation | Engine | |||
BA01.40-N-1020-01D | Nut for pressing the cylinder liner into the crankcase | Nm | 50 | ||
541 589 01 33 00
Removal and insertion device
Torque wrench handle
001 589 35 21 00
W01.40-0011-01
1 Screw bolts (1) into two diagonally opposite threaded holes in the crankcase.
W01.40-0012-01
2 Lay pressure plate (2) on cylinder liner (4) and lightly lubricate or grease contact surface of spindle (3) on pressure plate (2).
3 Place spindle (3) with counter stay of the installer on screw bolt (1) and tighten fully.
4 Press cylinder liner (4) into crankcase by turning nut (5) at spindle (3).
Tighten nut (5) using the prescribed tightening torque otherwise the installer will be distorted. To do this use a commercially available open end wrench, size 24 mm, without an extension.
5 Remove thrust spindle (3) with counter stay and pressure plate (2) and remove the screw bolts (1)
Do not detach or remove screw bolts (1), spindle (3) with counter stay and pressure plate (2) if protrusions are to be measured afterwards at cylinder liner (4).