W01.20-1082-09
1 | Clip | T1.2a | Cylinder 2 ignition coil | |
2 | Bracket | T1.3a | Cylinder 3 ignition coil | |
3 | Air intake duct | T1.4a | Cylinder 4 ignition coil | |
4 | Cylinder head cover | T1.5a | Cylinder 5 ignition coil | |
T1.1a | Cylinder 1 ignition coil | T1.6a | Cylinder 6 ignition coil |
Danger ! | Risk of injury caused by body parts being pinched or crushed as cab is tilted | Ensure that no one is within the tilting range of the cab as it is being tilted. Always tilt the cab all the way to the end position and secure with the safety strut. | |
Danger ! | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
| Notes on tilting the cab | ||
| Notes on avoiding damage through contamination and foreign objects | ||
| Remove/install | ||
1 | Tilt cab | Installation: Only tilt back cab after the leak test. | |
2 | Remove ignition coils of cylinder 1 to 6 (T1.1a to T1.6a) | ||
3 | Remove clamp (1) from bracket (2) | ||
4 | Remove bracket (2) | ||
5 | Remove air intake duct (3) | ||
6 | Check profiled seal of the cylinder head cover (4) for leaktightness | If the profile seal is leaky: | |
| |||
Replace profiled seal. | |||
7 | Remove cylinder head cover (4) | Tightening procedure | |
The screw/bolts for the cylinder head cover (4) are secured from falling out. | |||
Installation: Observe tightening procedure for cylinder head cover (4). | |||
Bolt, cylinder head cover to rocker arm housing | |||
8 | Install in the reverse order | ||
9 | Carry out an engine test run | ||
10 | Stop engine and check area around the cylinder head cover (4) for leaktightness | Visual inspection. |