AR01.00-S-2410A | Disconnecting and connecting engine wiring harness | 7.3.95 |
ENGINE 111.948 /978 in MODEL 638
S01.10-3000-09
S01.10-3001-06
1 Trim panel
2 Vacuum line
A13 PEC [PMS] control module
A13.2 Connector on side of vehicle
A13.3 CKP sensor connector
B63 Intake air temperature sensor
B63.1 Connector of intake air temperature sensor
M35.1 Connector of cruise control (code MD0 and MD9)
S19 Reverse lamp switch
S19.1 Connector of backup lamp switch
X91 Separation point circuit 30
X97 Connector of main wiring harness
X130 Connector of main wiring harness (codeH06)
| Remove/Install | ||
1 | Read out diagnostic trouble code memory of control module of pressurized engine control | Refer to Diagnosis Manual. | |
2 | Disconnect battery | ||
3 | Remove right headlamp | ||
4 | Remove cover (1) at control module of pressurized engine control (A13) | Installation: Cover must latch at front and rear audibly. | |
5 | Detach vacuum line (2) at control module of pressurized engine control (A13) | ||
6 | Disconnect connector of crankshaft position sensor (A13.3) at control module of pressurized engine control (A13) | ||
7 | Disconnect connector on side of vehicle (A13.2) at control module of pressurized engine control (A13) through actuating the lever. | Installation: Latch the plug at rear, position the lever vertically and connect the plug by pressing down the lever. | |
8 | Open tie strap (arrow) | ||
9 | Unscrew knurled nut at backup lamp switch (S19) and disconnect connector of backup lamp switch (S19.1) | Installation: Tighten knurled nut finger-tight. | |
10 | Disconnect connector of intake air temperature sensor (B63.1) at intake air temperature sensor (B63) | ||
11 | Separate tie strap (arrows) at protection hose (3) and pull back protection hose (3). | ||
12 | Separate separation point circuit 30 (X91) | ||
13 | Remove plug pocket at splash water reservoir and take out electrical connectors | ||
14 | Disconnect connector of main wiring harness (X97) | ||
15 | Disconnect connector of main wiring harness (X130) | if AC (code H06) fitted | |
16 | Disconnect connector of cruise control (M35.1) | on cruise control (code MD0 or MD9) | |
17 | Install in the reverse order |