000 589 13 99 00
Blade holder with clamping pliers
Wiring harness repair kit, basic
New passenger vehicle wiring harness repair kit
JPT / SPT blade
220 589 04 99 00
220 589 01 99 50
220 589 01 99 61
MCP 2.8 / Fl blade. 2.8 / JPT / SPT
000 589 13 99 30
P54.18-2474-01
Unfasten secondary release on version with locking bar
1 Using a suitable tool, move locking bar (1) in direction of arrow out of locked position.
P00.19-3527-01
Unfasten secondary release on version with retaining cap (shown on Junior Power Timer, micro quadlock system (MQS) connector)
2 Using a suitable tool, pry up the lock tab on the retaining cap (6).
3 Move retaining cap (6) in direction of arrow up to the stop.
P00.19-2962-01
Unfasten secondary release on version with lock tab
4 Insert suitable tool underneath locking tabs (1).
5 Pry up the lock tabs (1) in direction shown by arrow.
P00.19-3030-06
Unpin contact pins from the connector
6 Insert blade holder with clamping pliers with JPT/SPT blade or MCP 2.8/Fl blade. 2.8/JPT/SPT blade from the front through the openings in contact cavity of connector housing (3).
This results in the spring shackles of the contact pin (2) being compressed.
7 Remove contact pin (2) from connector housing (3) by gently pulling the relevant cable.