000 589 13 99 00
Blade holder with clamping pliers
Wiring harness repair kit, basic
New passenger vehicle wiring harness repair kit
MQS blade
220 589 04 99 00
220 589 01 99 50
220 589 01 99 60
P00.19-3027-01
Unfasten secondary release on version with lock tab
1 Push suitable tool underneath locking shackles (1).
2 Pry up the lock tabs (1) in direction shown by arrow.
P00.19-3011-06
Unpin contact pins from the connector
3 Insert blade holder with clamping pliers and MQS blade from front side though opening above contact cavity of connector housing (3).
This presses down the spring shackle at the contact pin (2).
4 A slight tug on the corresponding cable will pull the contact pin (2) out of the cavity of the plug.
Foil contacts must be unpinned at the same time. Tug on the foil while pressing down the spring to remove the foil.