AP82.10-P-8260-02GI | Check setting of high beam | ||
Danger | Risk of death when working on component parts and systems with U >= 30 V alternating voltage (AC) or U >= 60 V direct voltage (DC) | Do not touch damaged or defective live component parts and lines or non-insulated electrical connections and lines. | |
Danger | Risk of explosion/risk of fire caused by highly flammable materials in the vicinity of damaged xenon bulbs. Risk of injury caused by UV light, hot components on xenon headlamps and glass splinters produced by bursting xenon bulbs. Risk of poisoning caused by inhalation of mercury vapors and by swallowing of/skin contact with toxic salts and mercury compounds. | Do not touch parts conducting high voltage. Persons with active electronic implants (e.g. cardiac pacemakers) must never work on xenon headlamps. Switch off the entire lighting system. Wear insulated safety shoes, safety glasses and protective gloves. Remove highly inflammable materials from the danger zone. Ensure sufficient ventilation in the working area. |
Illustrated: model 176 |
01 | Headlamp aimer |
1 | Central mark |
H | Height adjusting screw |
S | Side position adjusting screw |
P82.10-7057-06
The center of the light beam must be positioned on the central mark (1) in the headlamp aimer (01).
1 | Check setting of high beam. |
In event of deviation, check that bulb is seated correctly in headlamp. |
Do not make any correction to the adjustment screws for the headlamp height adjustment (H) and the adjustment screws for the headlamp side adjustment (S), as this would adjust the previously set low beam. |