Parameterize | |||
1 | Connect the diagnostic equipment | Turn on the ignition of the vehicle. | |
If any message is shown in the steps next: | |||
| |||
Select "F2" to continue the procedure. | |||
2 | Start the program "XENTRY Diagnostics" | Select the brand "Mercedes-Benz". | |
3 | Select the option "Bus" | Next, choose the vehicle family. | |
4 | Select "All Types" | Click in continue. | |
5 | Select all in "Engines an Gearboxes" | Click in continue. | |
6 | Select "stethoscope" | ||
7 | Select "Quick Test" | Advance with "F3". | |
A question regarding the download of texts for instrument cluster updating will be shown. Advance with F4 and select the option "No". | |||
The result of the "Quick Test" is presented in " MR Engine Control". Pay attention to the indication "F - Active Failure" in the "MR Engine Control" unit. | |||
8 | Select "MR Engine Control" | Advance with "F3". | |
9 | Select "Current failure code" | The failure code "16995" will be presented. This code indicates that the system is "switched off". | |
Advance with "F3". | |||
10 | Select the failure code "16995" | Advance with "F3". | |
A question regarding the "SCR activation" is shown. Advance with "F3". | |||
11 | Switch the ignition on and off | The message "SCR system activated" is presented. Advance with "F2". (the failure "16995" must be shown scratched). | |
Activate the module | |||
12 | Return to "MR Engine Control" unit | Return by selecting "F1", | |
13 | Select "Control Unit Adaptation" | Advance with "F3". | |
14 | Select "Putting into operation for Euro 4 / 5 | Advance with "F3". | |
In this moment, an automatic routine of "10 steps" starts to put the system in operation. | |||
15 | Finish the activation procedure | Wait an execution of about 9 minutes between the steps 1 and 10, switch the ignition off and on when requested, and finish the procedure by selecting "F2". | |
The routine will be interrupted if one or more failures is found. In these cases, after correcting the indicated failures, the procedures must be re-started. | |||
If the correction of one or more failures depend on the re-parameterization of one or more electronic units: | |||
| |||
Consult the "ProParts" manual. | |||
16 | Remove the diagnostic equipment |