P46.00-2078-11
Shown on engine 272
1 Cap
1a Dipstick
2 Expansion reservoir
P46.00-2118-07
Shown on engine 156
1 Cap
2 Expansion reservoir
3 Front engine cover
1a Dipstick
P46.00-2106-07
Shown on engine 642
1 Cap
2 Expansion reservoir
1a Dipstick
| Checking | ||
Danger! | Risk of injury to skin or eyes caused by hydraulic fluid spraying out under high pressure. Risk of poisoning caused by swallowing hydraulic fluid. | Depressurize the hydraulic system completely before starting any work on the system. Wear protective clothing and safety glasses. | |
| Before opening the hydraulic circuit of the power steering, thoroughly clean the surrounding area of the separation point. Even the smallest dirt particles introduced into the hydraulic components can lead to malfunctions and damage to the power steering | ||
1 | Turn key in ignition lock into position 0 | ||
2 | Open engine hood and raise to vertical position | ||
| Opening engine hood, moving to upright position and closing | ||
3.1 | Remove engine trim panel | Engine 642 | |
| Remove/install engine cover | ||
3.2 | Remove front engine cover (3) | Engine 156 | |
4 | Remove cap (1) of power steering expansion reservoir (2) | Press the cap (1) downwards and turn counterclockwise through 90°. | |
5 | Wipe off oil dipstick (1a) with a fluff-free rag and seal the expansion reservoir (2) with cap (1) | Press the cap (1) downwards and turn clockwise through 90°. | |
6 | Remove the cap (1) again and read off the oil level on the oil dipstick (1a), correct the oil level if necessary | Observe the oil temperature and level marks on the oil dipstick (1a). | |
To avoid measurement errors: hold the oil dipstick (1a) vertical. | |||
If the fluid level is too low, determine cause and remedy against a separate order | |||
MB steering gear oil | |||
7 | Seal expansion reservoir (2) with cap (1) | ||
8.1 | Reinstall engine cover | Engine 642 | |
| Remove/install engine cover | ||
8.2 | Install front engine cover (3) | Engine 156 | |
9 | Close engine hood | ||
| Opening engine hood, moving to upright position and closing |
Steering gear