Illustration shows model 169 with ENGINE 266 |
1 | Underfloor paneling |
2 | Adjuster |
2a | Jam nut |
P42.20-2222-05
| Check | ||
Danger ! | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by vehicle manufacturer. | |
1 | Pull parking brake lever to first notch | If the force required to do this is <80 N, the length of the parking brake cables must be adjusted. | |
2 | Release parking brake lever | ||
3 | Raise vehicle with vehicle lift | ||
| |||
| Remove | ||
4 | Remove section of underfloor paneling (1) | MODEL 169.006/007/008/031/032/033/034/090 | |
| MODEL 169.006/007/008/031/032/033/034 | ||
Adjust | |||
5 | Loosen lock nut (2a) | ||
6 | Pre-tension parking brake cables by turning adjuster (2) | Pre-tension parking brake cables until parking brake shoes are pushed firmly against brake drums. It must no longer be possible to turn the rear wheels by hand. | |
7 | Loosen adjuster (2) several threads | | |
The parking brake cables must be slightly under tension when not actuated and must not hang down loosely. | |||
8 | Secure adjuster (2) by tightening lock nut (2a) | ||
| Install | ||
9 | Install section of underfloor paneling (1) | MODEL 169.006/007/008/031/032/033/034/090 | |
| MODEL 169.006/007/008/031/032/033/034 | ||
10 | Lower vehicle | ||
| Check | ||
11 | Pull parking brake lever to first notch | The force required to do this must be 110 to 150 N; if necessary, release the parking brake lever and repeat the adjustment procedure. |