P42.10-3099-09
Show on model 253.3 |
1 | Expansion reservoir | 3 | Left rear engine compartment paneling | |
2 | Cap |
Warning | Risk of injury. Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | |
Danger | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
Caution | Risk of poisoning from swallowing brake fluid. Risk of injury from skin and eye contact with brake fluid | Only pour brake fluid into suitable and appropriately marked containers. Wear protective clothing and eye protection when handling brake fluid. | |
Danger | Risk of accident when commissioning the vehicle due to a lack of braking effect when the service brake is operated for the first time after repair work. | Before starting the engine, actuate brake pedal several times until pressure is built up and maintained in the brake system. | |
Topical note | Notes on repairs to brake system | ||
Topical note | Notes on handling, transport and storage of composite brake disks | ||
Topical note | Notes on handling, transport and storage of ceramic brake disks | ||
Topical note | Brake fluid notes | ||
| Remove | ||
1 | Remove left rear engine compartment trim (3). | ||
| Clean | ||
2 | Clean area surrounding cap (2) and expansion reservoir (1). | ||
| Remove | ||
3 | Unscrew cap (2). | ||
4 | Extract brake fluid from expansion reservoir (1). | ||
5 | Add new brake fluid up to the max. mark in the expansion reservoir (1). | ||
6 | Connect filling and bleeding unit at expansion reservoir (1) and switch on. | | |
Change fluid | |||
7 | Lift vehicle with lifting platform. | ||
| |||
8 | Renew brake fluid. | ||
| General brake fluid | ||
| Brake fluids (DOT 4 plus) | ||
| Model 213, 238 | ||
| Model 253 | ||
| Model 257, 290 | ||
| |||
Model 213, 238, 257, 290Bleed screw to brake caliper | |||
Model 213, 238, 257Bleed screw at brake caliper | |||
Model 290Bleed screw at brake caliper | |||
Model 253Bleed screw to brake caliper | |||
Model 253Bleed screw at brake caliper | |||
If the bleed valve is not accessible, | |||
| |||
remove/install wheel and tire assembly. | |||
After obtaining special order. | |||
9 | Replace clutch operation system brake fluid. | Vehicle with manual transmission. | |
| General brake fluid | ||
| Brake fluids (DOT 4 plus) | ||
| Model 213, 238, 253 with transmission 716.7 | ||
| |||
Model 213, 238, 253 with transmission 716.7Bleed screw at clutch slave cylinder | |||
| Check | ||
10 | Check brake system for leaks. | ||
11 | Check clutch operation for leak tightness. | Vehicle with manual transmission. | |
| Install | ||
12 | Lower vehicle with vehicle lift. | ||
| |||
13 | Disconnect filling and bleeding unit. | ||
| Check | ||
14 | Check fluid level in expansion reservoir (1). | ||
| Install | ||
15 | Screw on cap (2). | ||
16 | Install left rear engine compartment trim (3). |