Calibrating tire pressure monitor

AP40.15-W-4060-03A

Calibrating tire pressure monitor

Model

930, 932, 933, 934

with code RY2 (Tyre pressure monitoring system)

Model

930, 934

with code RY1 (Tire pressure monitor for rear axle)

1

Move steering lock to drive position.

2

Repeatedly press the button
(3 or 4) to call up the "Settings" menu.

3

Repeatedly press the button
(1 or 2) to adjust the bars to the "Configuration" menu.

4

Press button (5 or 6) until the "Open the diagnosis menu" menu is displayed and open the diagnosis menu by pressing button (1).

5

Call up the "Diagnosis" menu by pressing button (4).

6

Select the "Service info" submenu by pressing button (1 or 2).

7

Select the "Calibrate" menu by repeatedly pressing button (5 or 6).

8

Press Reset button (8) for approx. 1 s until the multifunction display (7) shows "Calibrate all axles".

9

Press reset button (8) again for 1 second within 5 seconds in order to start the calibration process.

 The multifunction display (7) shows:
"Calibrate! Please wait" as well as the remaining time, e.g.
"55 seconds! Please wait".
If the calibration process is complete, the multifunction display (7) shows " Axle 2 calibration OK".
If a calibration fault is present, the multifunction display (7) shows " Axle 2 calibration. ERROR", in this case, check the tire pressure again.

10

Press the reset button (8) for 1 second in order to conclude the calibration process.

11

Repeatedly press the button
(3 or 4) to return to the basic menu.