1 | Nut |
2 | Spring saddle |
D32.20-1148-11
Retightening | |||
1 | Lift/jack up vehicle | ||
| |||
2 | Mark design position of nuts (1) relative to the spring saddle (2) | ||
3 | Loosen nut (1) by 45° | Each nut (1) must be loosened individually and then tightened again. The nuts (1) must not all be loosened at the same time. | |
4 | Tighten nut (1) | In the process, the nut (1) must at least reach the marked design position. If this is not the case, the specified torque may be exceeded. Solely maintaining the specified value is not permissible. | |
MODEL 909Spring U-bolt on rear axle spring to rear axle |