Shown: expansion reservoir at engine compartment sidewall |
1 | Differential lock operating mechanism expansion reservoir |
P29.00-2006-11
Shown: expansion reservoir at bulkhead |
1 | Differential lock operating mechanism expansion reservoir |
P29.00-2007-11
Shown on rear axle in model 463.234 with code ZQ0 (G 500 4x42) |
2 | Cap |
P29.00-2031-05
Warning | Risk of injury. Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | |
Danger | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
Caution | Risk of poisoning from swallowing brake fluid. Risk of injury from skin and eye contact with brake fluid | Only pour brake fluid into suitable and appropriately marked containers. Wear protective clothing and eye protection when handling brake fluid. | |
Topical note | Brake fluid notes | ||
| Clean | ||
1 | Clean area surrounding cap and differential lock operating mechanism expansion reservoir (1) | ||
| Remove | ||
2 | Unscrew cap on differential lock operating mechanism expansion reservoir (1) | ||
3 | Suction off brake fluid from the differential lock operating mechanism expansion reservoir (1) | ||
4 | Add new brake fluid up to the max. marking in the differential lock operating mechanism expansion reservoir (1) | ||
5 | Connect filling and bleeding unit on differential lock operating mechanism expansion reservoir (1) and switch on | ||
| General brake fluid | ||
| Brake fluids (DOT 4 plus) | ||
Note operator's manual for filling and bleeder unit. | |||
6 | Lift vehicle on vehicle lift | ||
| |||
7 | Remove cap (2) on switch cylinder vent valve of front axle | ||
Change fluid | |||
8 | Connect receptacle to switch cylinder vent valve on front axle and open vent valve | | |
9 | Close switch cylinder vent valve of front axle and remove receptacle | Bleed screw to differential lock cylinder | |
| Install | ||
10 | Install cap (2) on switch cylinder vent valve of front axle | ||
| Remove | ||
11 | Remove cap (2) on switch cylinder vent valve of center vehicle axle | Vehicle with three vehicle axles. | |
Change fluid | |||
12 | Connect receptacle to switch cylinder vent valve on front axle and open vent valve | Vehicle with three vehicle axles. | |
| |||
13 | Close switch cylinder vent valve of center vehicle axle and remove receptacle | Vehicle with three vehicle axles. | |
Bleed screw to differential lock cylinder | |||
| Install | ||
14 | Install cap (2) on switch cylinder vent valve of center vehicle axle | Vehicle with three vehicle axles. | |
| Remove | ||
15 | Remove cap (2) on switch cylinder vent valve of rear axle | ||
Change fluid | |||
16 | Connect receptacle to switch cylinder vent valve on rear axle and open vent valve | | |
17 | Close switch cylinder vent valve of rear axle and remove receptacle | Bleed screw to differential lock cylinder | |
| Install | ||
18 | Install cap (2) on switch cylinder vent valve of rear axle | ||
| Check | ||
19 | Check differential lock operating mechanisms for leaktightness | ||
| Install | ||
20 | Lower vehicle with lifting platform | ||
| |||
21 | Switch off filling and bleeding unit and disconnect differential lock operating mechanism expansion reservoir (1) | Note operator's manual for filling and bleeder unit. | |
| Check | ||
22 | Check fluid level in differential lock operating mechanism expansion reservoir (1) | ||
| Install | ||
23 | Screw on cap of differential lock operating mechanism expansion reservoir (1) |