Shown on model 944 |
1 | Cap |
2 | Threaded cap |
3 | Sealing ring |
4 | Oil filter element |
5 | Oil drain screw |
6 | Oil dipstick guide tube |
7 | Oil dipstick (depending on vehicle equipment, a stop plug can also be installed) |
N18.00-2070-06
Draining | |||
Warning | Risk of injury caused by body parts being pinched or crushed as cab is tilted | Ensure that no one is within the tilting range of the cab as it is being tilted. Always tilt the cab all the way to the end position and secure it with the safety strut. | |
1 | Tilt cab | ||
Topical note | Notes on tilting the cab | ||
2 | Replace oil filter element (4) | ||
Replace sealing ring (3). | |||
Oil filter cover to oil filter housing | |||
3 | Remove bottom section of soundproofing | When draining engine oil from drain screw (5). | |
4 | Detach end cover (1) | ||
5.1 | Pull oil dipstick (7) or stop plug out of oil dipstick tube (6), extract engine oil through oil dipstick tube (6), insert oil dipstick (7) or stop plug into oil dipstick tube (6) | Suction off engine oil | |
Extract engine oil only when the engine is at normal operating temperature. | |||
5.2 | Drain engine oil from drain screw (5) of oil pan and fasten drain screw (5) | Drain engine oil | |
Only drain engine oil when engine is at normal operating temperature. | |||
Replace sealing ring for drain screw (5). | |||
Drain screw to oil pan | |||
Pour in | |||
6 | Check set engine oil quality in Telligent® maintenance system; if necessary, adjust engine oil quality of engine oil to be added | Only on vehicles with code (JW5) Telligent maintenance system | |
7 | Pour in the specified filling capacity of engine oil at the oil filler opening | ||
Notes on engine oil | |||
Engine oil | |||
8 | Attach end cover (1) | ||
| Check | ||
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
9 | Start the engine, allow to idle for 1 to 2 minutes at idle speed and then switch off the engine | Monitor oil pressure indicator. It must indicated oil pressure after a few seconds. Do not rev up engine as long as no oil pressure is indicated. | |
10 | After a waiting time of approx. 5 minutes, check oil level on display; correct oil level if necessary |
| |
Model 374.6 with body 944.890, model 375.4 with body 375.860, model 940, 942, 943, 944 with body 944.890 | |||
The waiting time must be maintained. | |||
11 | Check threaded cap (2) and, if necessary, drain screw (5) of oil pan for leak tightness | ||
12 | Install bottom sections of soundproofing | ||
Warning | Risk of injury caused by body parts being pinched or crushed as cab is tilted | Ensure that no one is within the tilting range of the cab as it is being tilted. Always tilt the cab all the way to the end position and secure it with the safety strut. | |
13 | Tilt cab back into driving position | ||
Topical note | Notes on tilting the cab |