1 | Oil filter screw-on cover |
2 | Oil filter element |
3 | Sealing ring |
4 | Oil dipstick |
5 | Oil-dipstick guide tube |
6 | Left front engine cover |
7 | Left engine suction air duct |
P18.00-2342-06
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
Caution | Risk of injury to skin and eyes due to handling of engine oil. Risk of poisoning caused by swallowing engine oil | Wear protective gloves, protective clothing and safety glasses. | |
Notes on engine oil and filter changes | |||
| Remove | ||
1 | Allow engine to warm up | Coolant temperature min. 80 °C. | |
2 | Pull oil dipstick (4) out of oil-dipstick guide tube (5) and wipe off using lint-free cloth | The oil dipstick(4) and oil-dipstick guide tube(5) can be located at the front or rear of the engine, depending on the model series involved. | |
3 | Extract engine oil through oil-dipstick (5) guide tube | ||
4.1 | Remove left front engine cover (6) | Depending on the model series involved, either the left front engine cover (6) or the left engine air intake duct (7) has to be removed so to gain access to the oil filter cap_(1). | |
4.2 | Remove left engine air intake duct (7) | Depending on the model series involved, either the left front engine cover (6) or the left engine air intake duct (7) has to be removed so to gain access to the oil filter cap_(1). | |
5 | Remove oil filter threaded cap (1) | Unscrew the oil filter threaded cap (1) (depending on the version) using a socket wrench bit. | |
Wrench socket | |||
6 | Remove oil filter threaded cap (1) | ||
7 | Replace oil filter element (2) | ||
8 | Replace sealing ring (3) | ||
| Install | ||
9 | Install oil filter threaded cap (1) | Unscrew the oil filter threaded cap (1) (depending on the version) using socket. | |
Mount, oil filter housing cover | |||
Wrench socket | |||
10 | Remove engine oil extractor | ||
11 | Insert clean oil dipstick (4) into oil-dipstick guide tube (5) | ||
12 | Add engine oil | | |
Engine oilEngine oil | |||
| Check | ||
13 | Run engine until it is at operating temperature, and check for leaktightness | Coolant temperature min. 80 °C. | |
In the event of leakage: | |||
| |||
Determine and rectify cause, subject to separate repair order. | |||
14 | Switch off engine | ||
15 | Check engine oil level using oil dipstick (4); correct if necessary | ||
Insert oil dipstick (4) into the oil-dipstick guide tube (5) until the end stop and hold in for a duration of at least 3 seconds. | |||
| Install | ||
16.1 | Install left front engine cover (6) | If the left front engine cover (6) was removed. | |
16.2 | Install left engine air intake duct_(7) | If the left engine air intake duct (7) was removed. |
103 589 02 09 00
Wrench socket