Prepare radio remote control wiring harness for retrofit

AN83.70-D-0002-02S

Prepare radio remote control wiring harness for retrofit

MODEL

906

with CODE H12 (Auxiliary heater (warm water))

1

Branch off BN line (1.3) with CLS 1 cockpit ground point cable lug (3) from stationary heater Telestart receiver sub wiring harness (1.1).

2

Branch off GN line (1.2) from stationary heater Telestart receiver sub wiring harness (1.1).

3

Unpin lines of stationary heater Telestart receiver sub wiring harness (1.1) from 6-pin electrical connector (stationary heater Telestart receiver) (1).

4

Cut off contact springs of GN line (1.2), BN line (1.3), OG line (1.4) and RD/YE line (1.6) of stationary heater Telestart receiver sub wiring harness (1.1).

5

Attach corresponding contact springs for 12-pin electrical connector (stationary heater Telestart receiver) (1) at GN line (1.2), BN line (1.3), OG line (1.4) and RD/YE line (1.6) of stationary heater Telestart receiver sub wiring harness (1.1).

6

Plug GN line (1.2) of stationary heater Telestart receiver sub wiring harness (1.1) into provided 12-pin electrical connector (stationary heater Telestart receiver) at slot 11.

7

Plug BN line (1.3) of stationary heater Telestart receiver sub wiring harness (1.1) into provided 12-pin electrical connector (stationary heater Telestart receiver) at slot 1.

8

Plug OG line (1.4) of stationary heater Telestart receiver sub wiring harness (1.1) into provided 12-pin electrical connector (stationary heater Telestart receiver) at slot 8.

9

Plug RD/YE line (1.6) of stationary heater Telestart receiver sub wiring harness (1.1) into provided 12-pin electrical connector (stationary heater Telestart receiver) at slot 7.

10

Cut off fuse box (6) of RD/YE line (1.6) and extend RD/YE line (1.6) with corresponding cable by 0.5 m.

11

Cut off contact spring of OG line (1.4) and extend OG line (1.4) with corresponding cable by 1 m.

12

Cut off contact spring of GN line (1.2) and extend GN line (1.2) with corresponding cable by 1 m.

13

Attach corresponding contact spring for fuse block 2 (9 fuses) (F55/2) at extended end of RD/YE line (1.6).

14

Attach corresponding contact spring for MWH [HLS] electrical connector (X18/56) at extended end of OG line (1.4).

15

Attach corresponding contact spring for 10-pin heater booster/stationary heater button electrical connector (2) at extended end of GN line (1.2).

16

Prepare 3 m OG line (1.5) with corresponding cable, attach corresponding contact spring for MWH [HLS]/cockpit electrical connector (X18/56) at one end and at other end attach corresponding contact spring for 4-pin hot water auxiliary heater electrical connector (5).