ar1322d1202we

Remove/install poly-V belt

Typ ar · ämne 13.22 · version 0103 · 2011-08-18

Gäller för: ENGINES 651 in MODEL 900 ENGINES 651.955 /956 /957 in MODEL 906

Inte tillgängligt på ”sv”; visas på Engelska.

Placering

Funktionsgrupp 1 Motor › 13 Luftkompressor, remtransmissioner › 13.22 Enkelrems-transmission — Serie 651 · Serie 900 · Serie 906

EinPAS 15 Motor › 15.18 Remdrivning › 15.18.30 Rem/remskiva/spännanordning/bryttrissa — Serie 651 · Serie 900 · Serie 906

AR13.22-D-1202WE

Remove/install poly-V belt

10.8.11

ENGINES 651 in MODEL 900

ENGINES 651.955 /956 /957 in MODEL 906

Remove/install poly-V belt

D13.22-1127-06

Shown for vehicles with code (HH9) Regulated air conditioning, (Tempmatic)

1 Poly-V belt

Remove/install

Danger!

Risk of injury caused by moving parts that can pinch, crush or, in extreme cases, even sever extremities

No parts of the body or limbs should be within the operating range of the mechanism when moving components.

AS00.00-Z-0009-01A

1

Remove engine trim panel

AR01.10-D-2405WE

2

Remove poly-V belt for 2nd refrigerant compressor

For model 900 with code (HK4) Rear A/C, enhanced or for
model 906 with code (H08) High performance A/C

AR13.21-D-0160WE

3

Loosen poly-V belt (1)

AR13.22-D-3902-05WE

4

Remove poly-V belt (1) from belt pulley, guide pulley and remove to the rear

Installation: Put poly-V belt (1) in place according to the routing diagram.

Running diagram of poly-V belt (1)

AR13.22-D-3902-02WE

Checking

5

Check belt pulley profile, guide pulleys and clamping device

Installation: Replace belt pulley or major assemblies, guide pulleys and clamping device if there is damage.

6

Check poly-V belt (1) for wear and damage

Installation: Replace poly-V belt (1) if there is damage.

AR13.22-S-1351S

7

Install in the reverse order

Danger!

Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running

Secure vehicle to prevent it from moving by itself.
Wear closed and snug-fitting work clothes.
Do not touch hot or rotating parts.

AS00.00-Z-0005-01A

8

Perform an engine test run and check poly-V belt (1) for correct running; lay on poly-V belt (1) again if necessary

Refererade dokument