AR91.60-W-0624C | Remove/install restraint systems control unit | 12.9.11 |
MODEL 940.###, 942.###, 943.###, 944.### #L as of 489810 with BODY 944.890 with CODE (SA5) Driver airbag
MODEL 950.###, 952.###, 953.###, 954.### #L as of 489810 with BODY 940.890 with CODE (SA5) Driver airbag
MODEL 970.###, 972.###, 974.###, 975.###, 976.### #L as of 489810 with BODY 972.890 with CODE (SA5) Driver airbag
W91.60-1041-11
Shown on vehicle with code (F07) Cab S (short)
1 Grab handle
2 Wheel well lining
3 Floor covering
4 Air duct
5 Rear wall paneling
6 Cover
A40 Supplemental restraint system (SRS)
| Remove/install | ||
| Information on preventing damage to electronic components due to electrostatic discharge | ||
1 | Disconnect ground lead from battery | ||
2 | Move driver seat forward, fold backrest forward | ||
3 | Fold floor covering (3) behind driver seat forward | ||
4 | Remove support rod (1) from B-pillar | ||
5 | Remove operating unit for level control | Only on vehicles with level control. | |
6 | Remove wheel well paneling (2) | ||
7 | Remove air duct (4) of auxiliary heating | Only with code (F07) Cab S (short) with code (HZ3) Warm air auxiliary heater, | |
8 | Remove cover (5) at rear panel | Only with code (F07) Cab S (short). | |
9 | Remove cover (6) | ||
10 | Release and disconnect electrical connector at supplemental restraint system (SRS) control unit (A40) | ||
11 | Remove supplemental restraint system (SRS) control unit (A40) | Installation: The arrow on the housing of the supplemental restraint system (SRS) control unit (A40) must point in the direction of travel. | |
12 | Install in the reverse order | ||
13 | Parameterize supplemental restraint system (SRS) control unit (A40) with Star Diagnosis | Only if supplemental restraint system (SRS) control unit (A40) was replaced. |