AR83.70-D-5758C | Remove/install glow plug | 8.9.97 |
MODELS 901.32#, 902.32# /42#, 903.32# /42#, 904.32# /42# ## as of 753731 as of 3.11.97 with CODE (H11) Warm air auxiliary heater
D1L-C compact heater
MODELS 901.62#, 902.62#, 903.62#, 904.62#, 905.62# ## up to 382001 up to 11.3.02 with CODE (H11) Warm air auxiliary heater
D1L-C compact heater
D83.70-1302-06
1 Gasket
2 Cover
3 Bolt
4 Nut
5 Glow plug connection line
6 Glow plug
7 Sealing ring
8 Glow plug screen
9 Auxiliary heating control unit
10 14-pin plug
| Remove/Install | ||
Danger! | Risk of explosion from fuel vapors, risk of poisoning from inhaling combustion gases and risk of injury from burns during and after operation of heater unit | Do not operate stationary heater, auxiliary heater or engine with heater booster in closed areas or while filling fuel tank. Allow heater unit to cool down after operation and wear protective gloves. | |
1 | Unscrew bolt (3) and remove cover (2) with gasket (1) | Installation: Check gasket (1) for damage and replace if necessary. | |
2 | Unlock 14-pin plug (10) and disconnect from auxiliary heater control unit (9) | ||
3 | Unscrew nut (4) | ||
4 | Remove connection lines (5) from the glow plug (6) | ||
5 | Unscrew glow plug (6) | ||
6 | Remove sealing ring (7) | Installation: Replace sealing ring. | |
7 | Remove glow plug screen (8) | Installation: Observe installation position of guide lug (arrow A). The bore for glow plug ventilation (arrow B) must be unobstructed | |
8 | Install in the reverse order |