Shown on left rear door (2) |
1 | Bearing bracket |
2 | Rear door |
3 | Seals |
4 | Cable |
S72.12-4521-06
Warning | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
Topical note | Notes on carrying out repair work in the vehicle interior | ||
| Remove/install | ||
1 | Move side window of rear door (2) completely to top | ||
2 | Remove outer door handle from rear door (2) | ||
3 | Remove seals (3) | ||
4 | Detach adhesive foil on inner door panel of rear door (2) until access opening (arrow A) is accessible | ||
5 | Push bearing bracket (1) backward, remove from door paneling, and remove from rear door (2) via access opening (arrow A) | Installation: Position control cable (4) behind bearing bracket (1) (arrow B). | |
6 | Detach control cable (4) from bearing bracket (1) and remove bearing bracket (1) | ||
7 | Install in the reverse order |