Remove/install cable cover in driver-side footwell

AR68.30-W-1335A

27.3.06

MODEL 940, 942, 943, 944 with BODY 944.890

MODEL 944 with BODY 944.899

MODEL 950.5/ 6, 952.5/ 6, 953.6, 954.5 with BODY 940.890

MODEL 950.5/ 6, 952.5/ 6, 953.6, 954.5 with BODY 940.899

MODEL 970, 972, 974, 975, 976 with BODY 972.890

MODEL 970, 972, 974, 975, 976 with BODY 972.899

W68.30-1015-11

Shown on body 972.890

1 Edge protection strip

2 Floor Covering

3 Wheelhouse lining

4 Operating unit for level control

W68.30-1104-11

Shown on body 972.890

5 Cable cover

 	Remove/install
1	Remove support rod on the B-pillar	 The support rod is inserted down below in the trim (3) on the wheelhouse.	AR68.70-W-0303C
2	Remove/install lower left footwell cover, driver-side	Model 940, 942, 943, 944 with body 944.890 model 950, 952, 953, 954 with body 940.890 Model 970, 972, 974, 975, 976 with body 972.890	AR68.30-W-1310-02C
		Model 944 with body 944.899 Model 950, 952, 953, 954 with body 940.899 Model 970, 972, 974, 975, 976 with body 972.899	AR68.30-W-1310B
3	Remove wheel well paneling (3)	 Disconnect electrical connector from level control operating device (4)
4	Remove cable cover (5) in footwell on the driver-side
5	Install in the reverse order