Repair materials
Number | Designation | Order number |
BR00.45-Z-1071-02A | Adhesive tape roll, gray Tesa tape, 50 meters 0.3X50, 236 mm | A 001 989 17 85 |
P68.30-2815-11
Shown on model 209.3 with code (414a) Electric glass tilting/sliding roof and code (882b) Interior monitoring (only with ATA)
1 Headliner
2 Parktronic system wiring harness
3 Wiring connection
4 Main wiring harness
5 Interior monitoring wiring harness (with code (882b) Interior monitoring (only with ATA))
Interior motion sensor transmitter and receiver (with code (882b) Interior monitoring (only with ATA))
1 Lay new headliner (1) down on suitable subsurface.
2 Place suitable clean spacers, e.g. foamed material or styrofoam pads below new headliner.
Do not use any hard or sharp-edged objects, otherwise covering of new headliner (1) will be damaged.
The foamed material or styrofoam pads prevent the new headliner (1) from sagging when performing the following steps.
3 Route new Parktronic system wiring harness (2) parallel to main wiring harness (4)
The old headliner (1) serves as a template for routing the wiring harness.
4 Glue new Parktronic system wiring harness (2) onto new headliner with an approx. 10 cm long strip of adhesive tape at a distance of approx. 10 cm.
Do not overcross new Parktronic system wiring harness (2) and main wiring harness (4) and apply sufficient number of strips of tapes, otherwise a short circuit on the headliner can result from chafing.