Remove/install clock spring contact

AR46.10-D-0200B

17.10.11

MODEL 690.6, 901.6, 902.6, 903.6, 904.6, 905.6 with CODE (SA5) Driver airbag

MODEL WD1, WD2, WD3, WD6, WD7, XD1, XD2, XD3, XD6, XD7, YD1, YD2, YD3, YD4, YD5, YD6, YD7

MODEL 901.6, 902.6, 903.6
except CODE (SA5) Driver airbag
with CODE (BB3) Electronic Stability Program

D46.10-1120-11

1 Steering column paneling

2 Electrical center

R5 Clock spring contact

X113 Horn clock spring contact connector

X125 Airbag clock spring contact connector

 	Remove/install
 Danger!	Risk of injury caused by performing testing or repair work on airbag or emergency tensioning retractor units.	Store airbag unit with deployment face up, do not subject to temperatures above 100 °C. When working on these units, disconnect the power supply.	AS91.00-Z-0001-01A
1	Remove steering wheel	Except code SA5 Driver airbag	AR46.10-D-0100C
		With code SA5 Driver airbag	AR46.10-D-0100D
2	Remove steering column cover (1).
3	Loosen electrical center (2)	 Leave cable connectors as well as electrical lines connected.
4	Determine connector for horn clock spring contact (X113) in the area of the electrical center and disconnect
5	Determine connector for airbag clock spring contact (X125) in the area of the electrical center and disconnect	With code SA5 Driver airbag
6	Unscrew the bolts (arrows) until the clock spring contact (R5) can be removed	 Do not unscrew bolts fully. The bolts act at the same time as an anti-twist guard and assembly aid.
7	Carefully take clock spring contact (R5) off steering column tube	 Do not twist clock spring contact (R5) and do not disassemble. With twisted clock spring contact (R5) see: 
		Set the clock spring contact to center position	AR46.10-D-0200-01A
8	Install in the reverse order