Shown on model 222 |
1 | Electrical connector |
A7/7 | BAS brake booster |
B64/1 | Brake vacuum sensor |
P43.10-2152-03
| Remove/install | ||
1 | Switch off ignition and remove transmitter key | ||
2 | Push down brake pedal several times | In order to reduce the given vacuum in the BAS brake booster (A7/7). | |
3 | Remove cover over brake fluid expansion reservoir | ||
4 | Release and disconnect electrical connector (1) from brake vacuum sensor (B64/1) | ||
5 | Pry brake vacuum sensor (B64/1) out of BAS brake booster (A7/7) | Installation: Make sure that the seal plug and brake vacuum sensor (B64/1) are seated correctly. | |
Check seal plug for damage. | |||
Mounting wedge | |||
6 | Install in the reverse order | ||
| Check | ||
7 | Start engine and depress brake pedal several times | ||
8 | Turn off engine | ||
9 | Check leaktightness of brake vacuum sensor (B64/1) | Air flow noises must not be audible at the BAS brake booster (A7/7). |
110 589 03 59 00
Mounting wedge