MODEL | 172, 204, 207, 212, 218, 219, 231 |
1 | Before removing the centering sleeve, measure and note dimension (a). |
Depending on the version of the joint disk thickness, the specified press-in dimension may deviate when installing. |
P41.10-0211-01
2 | Knock centering sleeve out of propeller shaft using a suitable tool (arrow). |
P41.10-0014-01
3 | Drill a hole (10 mm dia.) at right angles through the centering sleeve (10) 15 mm from the end face of the centering sleeve (10). |
Only if it is not possible to knock it out. |
P41.10-0015-01
4 | Insert a drift through the hole and lever the centering sleeve (10) out of the propeller shaft using two assembly levers. |
Only if it was not possible to knock it out. |
P41.10-0016-01