1 | Front crossmember |
2 | Rear crossmember |
3 | Electrical wiring harness |
4 | Bracket |
5 | Right spring bracket |
6 | Bracket |
7 | Bracket |
8 | Left spring bracket |
W31.00-A030-76
Danger | Risk of explosion caused by paint vapors igniting. Risk of poisoning caused by inhaling paint vapors. | No smoking! No open fire! Use respiratory protection, protective clothing, gloves, safety glasses and protective skin cream. Ensure that the area is well ventilated. | |
Topical note | Notes on paintwork repairs | ||
Topical note | Notes on threaded connections fastened using a tightening angle-based tightening process | ||
| Remove | ||
1 | Remove electrical wiring harness (3) from holders (4, 6, 7). | Only if electrical wiring harness (3) is routed along front or rear crossmember (1, 2) to be removed. | |
The number of holders installed may differ. | |||
2 | Remove holders (4, 6, 7). | Only when the front or rear crossmember (1, 2) on which the holders are fastened is replaced. | |
3 | Remove front or rear crossmember (1, 2). | ||
| Install | ||
4 | Paint front or rear crossmember (1, 2) in frame color. | Only when replacing. | |
5 | Install front or rear crossmember (1, 2). | Cross member to spring bracket | |
6 | Install holders (4, 6, 7). | Only if they were removed. | |
7 | Paint new nuts and screws on front or rear crossmembers (1, 2) in frame color. | ||
8 | Attach electrical wiring harness (3) to holders (4, 6, 7). | If an electrical wiring harness (3) was removed. | |
Replace cable ties. |