P30.12-2014-09
1 Nuts
2 Accelerator pedal
5 Lug
3 Electrical connector
4 Guide
| Removing/installing | ||
1 | Switch off the ignition and remove the transmitter key from the EIS control unit | On vehicles with Keyless Go, code 889: Press Keyless Go start/stop button repeatedly until the ignition is switched off. Remove the transmitter key from the vehicle and store it in a location beyond its transmission range (at least 2 meters). | |
2 | Unscrew nuts (1) | ||
3 | Loosen accelerator pedal (2) | Pull out the accelerator pedal (2) in the upper part slightly and then push upwards (arrow), in order to loosen the lug (5). | |
4 | Remove accelerator pedal (2) | Installation: Pay attention to correct seating of the guide (4) in the cover under the instrument panel on the driver-side. | |
5 | Disconnect electrical connector (3) | ||
6 | Install in reverse order |